Практика
Practice
Диаграмма критического узла, отказ и исправление
Critical Detail Failure and Fix Diagram
Train student to read a detail as a failure-risk point and propose a simple design response.
- Статус
- Practice-only. Not separately checked. This mini-output trains one lesson skill. You may reuse it later if it helps your module project, but this practice task is not graded separately.
- Время
- 25 to 40 minutes.
ANY tool is allowed.
- paper and pen
- printed worksheet
- notebook
- PowerPoint
- Canva
- Figma
- tablet sketching app
- simple drawing app
- any other tool that helps you make the detail clearly
Create one Critical Detail Failure and Fix Diagram.
- 01
Choose one critical location, for example roof edge, window corner, wall base, material joint, cladding joint, wall and roof junction, wall and floor junction, timber and brick transition or glass and wall connection.
- 02
Split the page into two panels: failure on the left and fix on the right.
- 03
Draw the same detail location in both panels.
- 04
Show at least three materials or layers, for example cladding, frame, insulation, air barrier, glass, sealant, flashing or interior finish.
- 05
On the failure side, draw the water path. Show where water enters, collects or runs backward.
- 06
Add one air leakage or heat flow risk.
- 07
Mark thermal bridge, movement, aging or sealant risk if relevant.
- 08
Name the failure clearly, for example leak, air leak, thermal bridge, rot, crack or sealant-only failure.
- 09
On the fix side, draw one design response, for example flashing, drip edge, drainage gap, continuous air barrier, continuous insulation, movement joint or replaceable sealant.
- 10
Add one maintenance access note.
- 11
Finish with one trade-off sentence.
Наш пример
Используйте пример как ориентир для структуры, а не как шаблон для копирования.
Сначала попробуйте выполнить задание самостоятельно. Затем откройте пример для сравнения.
Пример скрыт.